DFRobot

Introduction: The DFRobot LM35 Linear Temperature Sensor is based on the semiconductor LM35 temperat.....

Introduction The MEGA IO Expansion Shield can be used for a variety of interactive works, it is o.....

Introduction This is a design for an open-source prototyping shield for Arduino Mega. It has tons.....

Introduction This motor has a long (0.365" or 9.27 mm), D-shaped metal output shaft that matches .....

Introduction The Arduino Nano I/O Shield acts as a breadkout board for the Arduino Nano and DFRdu.....

Pan and Tilt assembly for horizontal surface mount. Made using two DFRobot servo brackets. Perfect f.....

Introduction: Most project of Arduino may need more than two voltage supply. When feed with from 4.5.....

Introduction Combines the power of screw shield and prototyping shield. This Proto Screw shield o.....

Introduction Introduction: The DFRobot Relay Module blocks the number of electronic modules. It c.....

Introduction The mounting plate for RP5 tracked chassis is a high strength, non-friable, non-.....

Introduction The Arduino-Compatible Screw Shield is a terminal expansion board that can be screwe.....

Description: The 4x4 Keypad is a general purpose 16 button (4x4) matrix keypad. It comes ready to wo.....

INTRODUCTION: This tiny little orange heatsink is a perfect solution for cooling off small surface-m.....

Introduction This is a 300mm servo extension cable. This comes in very handy when your servo is f.....

Introduction This mounting bracket is designed for Sharp GP2D12/2D15. The color of bracket may.....

Introduction: The Si7021 I2C Humidity and Temperature Sensor is a monolithic CMOS IC integrating hum.....